+- XOR Userforum (https://forum.xor.eu)
+-- Forum: Products (https://forum.xor.eu/forumdisplay.php?fid=3)
+--- Forum: NerdSEQ (https://forum.xor.eu/forumdisplay.php?fid=6)
+---- Forum: Nerdseq issue / bugreport (https://forum.xor.eu/forumdisplay.php?fid=8)
+----- Forum: The really bad bugs -> crash (https://forum.xor.eu/forumdisplay.php?fid=15)
+----- Thread: [FIXED] loading sample blocks from table crashes nerdseq (/showthread.php?tid=1354)
[FIXED] loading sample blocks from table crashes nerdseq - shield - 03-19-2022
Hi,
I found another crash when using sample blocks
Putting a table on a sample track using the FX, and triggering a "load sample block" inside of this table results in the nerdseq crashing and immediately rebooting.
I tried to load the same sample block as in the previous discussion topic.
Related question: is there a way to trigger the loading of a sample block only once at the first time? This is what I tried to accomplish using the table.
RE: loading sample blocks from table crashes nerdseq - XORadmin - 05-03-2022
(03-19-2022, 01:54 AM)shield Wrote: Hi,
I found another crash when using sample blocks
Putting a table on a sample track using the FX, and triggering a "load sample block" inside of this table results in the nerdseq crashing and immediately rebooting.
I tried to load the same sample block as in the previous discussion topic.
Related question: is there a way to trigger the loading of a sample block only once at the first time? This is what I tried to accomplish using the table.
Ow I missed that here.
I’m going to check this. There is no ‘one time FX’ but you could use like FX2 where in the first line it loads the sample block and in the 2nd line you set the probability of that FX to 0. That would be a 1 timer. You can reset the probability setting on another point then again.