XOR Userforum
Use 4 inputs for audio in, mixer functionality, outputting stereo to sample outputs - Printable Version

+- XOR Userforum (https://forum.xor.eu)
+-- Forum: Products (https://forum.xor.eu/forumdisplay.php?fid=3)
+--- Forum: NerdSEQ (https://forum.xor.eu/forumdisplay.php?fid=6)
+---- Forum: Feature requests (https://forum.xor.eu/forumdisplay.php?fid=12)
+---- Thread: Use 4 inputs for audio in, mixer functionality, outputting stereo to sample outputs (/showthread.php?tid=1458)



Use 4 inputs for audio in, mixer functionality, outputting stereo to sample outputs - nullwave - 09-27-2022

Hello!

I was curious if it would be possible at some point to introduce a mixing feature on the nerdseq.

The use case would be to use the 4 inputs to receive audio, have an internal mixing bus, then send the output in stereo to the 2 sample outputs.
Maybe even have the ability to automate volume control through the sequencer Angel 

This would be very useful to have, but I'm not sure if the audio inputs would even support this to start.

I also know you are very busy but I figured I would at least ask!

Thanks for all you do on the nerdseq platform, it is much appreciated!

Regards,
nullwave


RE: Use 4 inputs for audio in, mixer functionality, outputting stereo to sample outputs - XORadmin - 09-27-2022

Too bad that is not possible as the inputs are only unipolar and not suitable for audio.


RE: Use 4 inputs for audio in, mixer functionality, outputting stereo to sample outputs - nullwave - 09-27-2022

Bummer, thank you for the answer!