+- XOR Userforum (https://forum.xor.eu)
+-- Forum: Products (https://forum.xor.eu/forumdisplay.php?fid=3)
+--- Forum: NerdSEQ (https://forum.xor.eu/forumdisplay.php?fid=6)
+---- Forum: General Questions (https://forum.xor.eu/forumdisplay.php?fid=17)
+---- Thread: CV input clipping (/showthread.php?tid=1478)
CV input clipping - skogn - 10-31-2022
Hi!
If I connect an external signal to any of the four CV Inputs, it gets measured in a ~ 0-2V range.
Any tips how to fix this?
Thanks in advance!
Cheers
Adam
RE: CV input clipping - XORadmin - 10-31-2022
(10-31-2022, 03:13 PM)skogn Wrote: Hi!
If I connect an external signal to any of the four CV Inputs, it gets measured in a ~ 0-2V range.
Any tips how to fix this?
Thanks in advance!
Cheers
Adam
I assume your inputs need to be calibrated.
Usually the auto calibration should do the job well and your input range will be 0 - 10 Volt again.
RE: CV input clipping - skogn - 10-31-2022
Ahh, excellent! Thanks for your reply!
Somehow I missed the auto-calibration part in the manual, will try it out ASAP!
Cheers!