+- XOR Userforum (https://forum.xor.eu)
+-- Forum: Products (https://forum.xor.eu/forumdisplay.php?fid=3)
+--- Forum: NerdSEQ (https://forum.xor.eu/forumdisplay.php?fid=6)
+---- Forum: General Questions (https://forum.xor.eu/forumdisplay.php?fid=17)
+---- Thread: Can you apply a table to channels 7 and 8? (/showthread.php?tid=1552)
Can you apply a table to channels 7 and 8? - soggybag - 04-04-2023
I have a pattern on channel 7 using the internal oscillator and an envelope. I wanted apply a table to transpose it. Is that possible?
RE: Can you apply a table to channels 7 and 8? - XORadmin - 04-04-2023
Yes, audio tracks can use tables
RE: Can you apply a table to channels 7 and 8? - soggybag - 04-05-2023
Thanks for the reply. How would you set that up? I’m trying to figure it out.
RE: Can you apply a table to channels 7 and 8? - XORadmin - 04-05-2023
Via the table FX.
Page 41 in the manual:
“ TABL → Start/assign table to the pattern part. So you can use the tables also for samples/waveforms. The numbers show the selected table. A table that has already been assigned is shown in the regular colour. Tables that are not assigned/used yet are greyed out (the ‘mute’ colour). You can assign them to an audio track by either press the OK button or by pressing the TABLE button. With the TABLE button the Table Screen is also directly entered, so the selected table can be edited. Note that tables generated in the audio tracks also can use the FX from the audio tracks.
A table number higher than 31 will set a ‘Stop Table’ command, shown by ‘STOP’”