+- XOR Userforum (https://forum.xor.eu)
+-- Forum: Products (https://forum.xor.eu/forumdisplay.php?fid=3)
+--- Forum: NerdSEQ (https://forum.xor.eu/forumdisplay.php?fid=6)
+---- Forum: General Questions (https://forum.xor.eu/forumdisplay.php?fid=17)
+---- Thread: Reset Out Nerdseq To Circadian Rhythms (/showthread.php?tid=1890)
Reset Out Nerdseq To Circadian Rhythms - aulicon - 10-16-2024
Hello community,
Proud owner of Nerdseq here. I've been trying to clock my tip top audio circadian rhythms from the nerdseq and I can't get the reset to work properly. The nerdseq reset out works great with my other sequencers, just the CR seems to have this issue. I tried using a note trigger out from the "more triggers 16" expander and that seems to work. However its not very practical and I would like to avoid that if possible. Any idea?
Thanks!
RE: Reset Out Nerdseq To Circadian Rhythms - XORadmin - 10-19-2024
The NerdSEQ doesn't send the reset pulse frequently but only if you stop the sequencer so all connected gear will 'resynchronize'.
You could try to send a reset pulse at the end or begin of your pattern using the SPFX command.
RE: Reset Out Nerdseq To Circadian Rhythms - aulicon - 10-21-2024
(10-19-2024, 10:54 PM)XORadmin Wrote: The NerdSEQ doesn't send the reset pulse frequently but only if you stop the sequencer so all connected gear will 'resynchronize'.
You could try to send a reset pulse at the end or begin of your pattern using the SPFX command.
Hi!
yes I tried the SPFX command as well as shift+start but the CR doesn't seem to receive the reset. My malekko voltage block and metropolix receive the reset from the Nerdeseq correctly. I wonder if this is a specific issue with the CR?
Thanks
RE: Reset Out Nerdseq To Circadian Rhythms - XORadmin - 10-21-2024
(10-21-2024, 02:39 PM)aulicon Wrote:(10-19-2024, 10:54 PM)XORadmin Wrote: The NerdSEQ doesn't send the reset pulse frequently but only if you stop the sequencer so all connected gear will 'resynchronize'.
You could try to send a reset pulse at the end or begin of your pattern using the SPFX command.
Hi!
yes I tried the SPFX command as well as shift+start but the CR doesn't seem to receive the reset. My malekko voltage block and metropolix receive the reset from the Nerdeseq correctly. I wonder if this is a specific issue with the CR?
Thanks
Maybe a CR setting?