+- XOR Userforum (https://forum.xor.eu)
+-- Forum: Products (https://forum.xor.eu/forumdisplay.php?fid=3)
+--- Forum: NerdSEQ (https://forum.xor.eu/forumdisplay.php?fid=6)
+---- Forum: General Questions (https://forum.xor.eu/forumdisplay.php?fid=17)
+---- Thread: switching mod output -5/+5 -> 0/+10 (/showthread.php?tid=313)
switching mod output -5/+5 -> 0/+10 - codydjango - 02-20-2019
Seems like this is possible but haven't been able to successfully figure it out. Read through the updated manual and didn't see anything, unless I'm misunderstanding how the FX can work...
The documentation says that the 12 CV outputs can be either "Range -5 Volt /+5 Volt or 0 Volt / +10 Volt" so to me that seems to indicate a switch somewhere...
Steps:
- 0/+10 signal patched into input 1
- setup record to record input 1 to mod 1
- monitor output of mod 1
- signal is now -5/+5
RE: switching mod output -5/+5 -> 0/+10 - skybox - 02-20-2019
The voltage selector switches are the physical toggles beneath the outs; the left toggle for cv, and the right toggle is for mod. If your switches are flipped the opposite ways that would explain why you are seeing these results.
Hope that helps!
RE: switching mod output -5/+5 -> 0/+10 - XORadmin - 02-20-2019
Yes, if toggle switch is on the left then the outputs that belong to the switch have a -5 to +5 volt range. So all voltages get a negative 5 volt offset.
RE: switching mod output -5/+5 -> 0/+10 - codydjango - 02-20-2019
Ha, of course. The most useful spot! I don't know why I figured it would be buried in settings.
It's a nice feeling, having a piece of gear so well designed!