+- XOR Userforum (https://forum.xor.eu)
+-- Forum: Products (https://forum.xor.eu/forumdisplay.php?fid=3)
+--- Forum: NerdSEQ (https://forum.xor.eu/forumdisplay.php?fid=6)
+---- Forum: General Questions (https://forum.xor.eu/forumdisplay.php?fid=17)
+---- Thread: LFO reset (/showthread.php?tid=315)
LFO reset - depaffect - 02-20-2019
Is there anyway to make the LFO reset on a note-on?
I've also tried using the ASL1 101 command on each note in the pattern under "FX 1" (my LFO is in automator slot 1) but it doesn't seem to do anything
Sorry ignore this thread. I got the above to work (it was on slot ZERO!) , and now I've realised it's more powerful to manually assign an LFO reset as per ASLx101.
RE: LFO reset - XORadmin - 02-20-2019
It works well for me. At the moment you send the ASL1 101 it resets the LFO to the start point (or the point where the phase is set to, which is the start point).
I just tested it.
RE: LFO reset - Acheface - 05-03-2020
I can't get an ASLx 101 reset to work on an LFO that is running only when an ASLx 0xx tells it to. Am I doing something wrong or could it be a bug?
Also, the meanings of ASL commands (start, reset, etc.) are not shown in the status bar of Trigger 16 or More CV 16 tracks.
RE: LFO reset - XORadmin - 05-05-2020
(05-03-2020, 03:54 PM)Acheface Wrote: I can't get an ASLx 101 reset to work on an LFO that is running only when an ASLx 0xx tells it to. Am I doing something wrong or could it be a bug?
Also, the meanings of ASL commands (start, reset, etc.) are not shown in the status bar of Trigger 16 or More CV 16 tracks.
It still resets with me. Do you try to reset a LFO while it is stopped?
The statusbar help for the Automator commands was left out for the expanders because of the lack of time. I will get them in there as well.
RE: LFO reset - Acheface - 05-05-2020
(05-05-2020, 07:29 AM)XORadmin Wrote: It still resets with me. Do you try to reset a LFO while it is stopped?Yes, and while it's running. It was in Tick mode, would that make a difference?
RE: LFO reset - XORadmin - 05-05-2020
(05-05-2020, 02:47 PM)Acheface Wrote:(05-05-2020, 07:29 AM)XORadmin Wrote: It still resets with me. Do you try to reset a LFO while it is stopped?Yes, and while it's running. It was in Tick mode, would that make a difference?
Oh...it doesn't reset of course in tick or pattern mode!
With 'Tick and Pattern' as clock source it is syncronised to the mainclock steps and not free running. With that the LFO starts with the pattern begin and ends with it's iteration at the end of a pattern (based on the mainclock). Pattern is a bit rougher and changes only every step while tick is 6 times faster and finer.