+- XOR Userforum (https://forum.xor.eu)
+-- Forum: Products (https://forum.xor.eu/forumdisplay.php?fid=3)
+--- Forum: NerdSEQ (https://forum.xor.eu/forumdisplay.php?fid=6)
+---- Forum: Nerdseq issue / bugreport (https://forum.xor.eu/forumdisplay.php?fid=8)
+----- Forum: Beauty and less important bugs/glitches (https://forum.xor.eu/forumdisplay.php?fid=16)
+----- Thread: Recording CV/Gate inputs is inaccurate (/showthread.php?tid=782)
Recording CV/Gate inputs is inaccurate - funqpatrol - 07-02-2020
Or at least it is very inconsistent, when recording some notes through the analog inputs (ie Rene into Nerdseq) I'm not getting the exact same notes, any advise on setting this up so what you actually put in is getting recorded accurately?
Thanks!
RE: Recording CV/Gate inputs is inaccurate - XORadmin - 07-03-2020
Are you sure that
A: your outputs of the Rene are calibrated well. So Note C-1 is exactly 1 volt and C-6 exactly 6 volt for example
B: Did you manually calibrated the inputs so they match with the Rene?
C: Are the CV outputs of the Rene generating any slew for the CV voltages so the voltage is not stable when the gate comes?
RE: Recording CV/Gate inputs is inaccurate - funqpatrol - 07-06-2020
(07-03-2020, 05:43 AM)XORadmin Wrote: Are you sure that
A: your outputs of the Rene are calibrated well. So Note C-1 is exactly 1 volt and C-6 exactly 6 volt for example
B: Did you manually calibrated the inputs so they match with the Rene?
C: Are the CV outputs of the Rene generating any slew for the CV voltages so the voltage is not stable when the gate comes?
Thanks for the insight, will make sure all these points care checked
RE: Recording CV/Gate inputs is inaccurate - Marizu - 07-07-2020
Just out of curiosity, I'm wondering what you are actually trying to record.
Rene and a number of other sequencers can change the CV (note/voltage) output value on steps where they don't generate a trigger.
NerdSeq CV recording can be set up in a number of ways. Are you recording gate and trigger?
Is your Rene sequence generating a trigger on every single step?
Also remember to check that Rene can have independent slews for change of X and change of Y.