+- XOR Userforum (https://forum.xor.eu)
+-- Forum: Products (https://forum.xor.eu/forumdisplay.php?fid=3)
+--- Forum: NerdSEQ (https://forum.xor.eu/forumdisplay.php?fid=6)
+---- Forum: Feature requests (https://forum.xor.eu/forumdisplay.php?fid=12)
+---- Thread: Gate length in time division (/showthread.php?tid=810)
Pages:
1
2
Gate length in time division - Cedre - 08-17-2020
Hi
Would it be possible to set the Gate/trigger length in time division (1/4 1/8 1/16 1/32 1/64) and not only in ms.
Thanks
Cedre
RE: Gate length in time division - mvdirty - 08-17-2020
I too would love to see something like this. As an addition or alternative: Duration as measured in steps would get things in the ballpark, and could interact interestingly with things like groove and perhaps also in turn with things like break/jump, looping patterns, carrying over into the next pattern in an island, etc.
RE: Gate length in time division - Cedre - 08-17-2020
(08-17-2020, 03:57 PM)mvdirty Wrote: I too would love to see something like this. As an addition or alternative: Duration as measured in steps would get things in the ballpark, and could interact interestingly with things like groove and perhaps also in turn with things like break/jump, looping patterns, carrying over into the next pattern in an island, etc.
Oh yes, duration in steps is a great idea for a tracker!!
+1
RE: Gate length in time division - pmarchitect - 08-19-2020
Absolutely. Time divisions win over ms for sequencing.
RE: Gate length in time division - XORadmin - 08-20-2020
You can either use tables for this. Also the Note off command is your gate over multiple steps friend.
RE: Gate length in time division - mvdirty - 08-20-2020
In my mind, tables are so closely associated with transposition that I don’t as often think of how far their FX can go. (I assume you’re referring to using the TRIG FX from within a table.) Thanks for the reminder!
RE: Gate length in time division - XORadmin - 08-20-2020
Yep exactly. And with the coming version the tables had a big makeover as well.
RE: Gate length in time division - mvdirty - 08-20-2020
(Omri Cohen voice) Very nice.
Looking forward to it!
RE: Gate length in time division - geremy - 07-08-2021
Apologies for the dumb question but I'm not sure how to manipulate gate length in time divisions with a table. I have read the manual, and I understand the use of tables for ratcheting, but not how to manipulate the gate length as a percentage of single step time. I assume it has to do with the speed setting? I'm not talking about multiple trigs per step, but the simple length of the single gate played on each step. Thanks!
RE: Gate length in time division - mgd - 07-08-2021
mvdirty already gave the answer to that in post #6 above:
"I assume you’re referring to using the TRIG FX from within a table"
You start your gate on the table step that you want it to go up and stop it some steps later. This also allows for delayed gates and lots of other stuff. The various timing options allow for more variability.
HTH,
Michael