+- XOR Userforum (https://forum.xor.eu)
+-- Forum: Products (https://forum.xor.eu/forumdisplay.php?fid=3)
+--- Forum: NerdSEQ (https://forum.xor.eu/forumdisplay.php?fid=6)
+---- Forum: NerdSEQ Expanders (https://forum.xor.eu/forumdisplay.php?fid=22)
+---- Thread: CV16 - 'add' modulation (/showthread.php?tid=963)
CV16 - 'add' modulation - Kubase - 01-15-2021
From the manual:
For each CV output there is an additional setting to decide if the Modulator (Envelope or LFO)
should be pure or added to the current Note/Pitch.
I'm not sure how to set this up. If I have note cv coming out CV1, how do I add, say an LFO to it from another CV output?
RE: CV16 - 'add' modulation - Falafel Biels - 01-28-2021
Use add if you would like to add vibrato to your note. Then in the note column, press shift+ok a few times until an envelope shows up. Shift + curor right a few times until it turns into an LFO.
Now the LFO is added to your pitch.
To get LFO from a seperate output, simply enter an LFO event in the column that corresponds to that output.
RE: CV16 - 'add' modulation - XORadmin - 01-28-2021
The trick is that you don't use the LFO from another output but you just enable a LFO to the current output.
RE: CV16 - 'add' modulation - Kubase - 02-02-2021
Great, thanks. The bit I was missing was using the same column, as in what to do if there are no gaps - of course you just divide the clock!
Very controllable vibrato and modulation - love it.