+- XOR Userforum (https://forum.xor.eu)
+-- Forum: Products (https://forum.xor.eu/forumdisplay.php?fid=3)
+--- Forum: NerdSEQ (https://forum.xor.eu/forumdisplay.php?fid=6)
+---- Forum: General Questions (https://forum.xor.eu/forumdisplay.php?fid=17)
+---- Thread: No table presets in my SD cards (/showthread.php?tid=1117)
Pages:
1
2
No table presets in my SD cards - olivertruth - 05-28-2021
Hello,
I see in the manual (P68) : Nerd Menu in the table screen (SHIFT+NERD) to get to the presets and
"The following presets are available",
But, i bought my Nerdseq in second Hand, and : Preset Empty...How can i have this preset?
Thanks you!!!!
Olivier
RE: No table presets in my SD cards - XORadmin - 05-28-2021
The presets are not on the SD card.
I assume you just use an old firmware.
Update to the latest and it’ll be fine.
RE: No table presets in my SD cards - olivertruth - 05-29-2021
Hi, Thank you for your answer, but i'm in the new firmware (1.24)
I try this morning to use the new firmware again, updating Succeed, and preset always empty :-(
I 'm formating my sd card...
and try again
RE: No table presets in my SD cards - XORadmin - 05-29-2021
The sd card is not needed for all of this.
If you run v1.24 then it is there.
Just shift+ nerd in the table. Go to the preset rule and select as always with shift left/right. Press OK to enable the preset.
I’m sure it’s fine!
RE: No table presets in my SD cards - olivertruth - 05-29-2021
so, i'm just so sorry, yes, it's work :-(
I'm a newbee with Nerdseq, but already in love!!!!
What a module!!!!
thanks thanks thanks
RE: No table presets in my SD cards - XORadmin - 05-29-2021
Don’t worry :-)
Just remember that editing always happens like this.
RE: No table presets in my SD cards - olivertruth - 05-29-2021
ok ;-)
RE: No table presets in my SD cards - joesh - 06-08-2022
I have the same problem except there's no presets. I select Shift+Nerd in the table (I imagine it doesn't matter what row you're in) and I get a screen which just has two possibilities (three if you count abort):
Preset > Empty
Release Table
Can you make any suggestions?
BTW, I'm in 1.25A.
Thanks in advance.
RE: No table presets in my SD cards - XORadmin - 06-08-2022
(06-08-2022, 03:21 PM)joesh Wrote: I have the same problem except there's no presets. I select Shift+Nerd in the table (I imagine it doesn't matter what row you're in) and I get a screen which just has two possibilities (three if you count abort):
Preset > Empty
Release Table
Can you make any suggestions?
BTW, I'm in 1.25A.
Thanks in advance.
See answer #4
RE: No table presets in my SD cards - joesh - 06-08-2022
Except there are no preset rules?
As you see I go into a table - I select Shift+Nerd in the table (I imagine it doesn't matter what row you're in) and I get a screen which just has two possibilities (three if you count abort):
Preset > Empty
Release Table
As you can see, these are the only possibilities, I don't have any rules to choose from.