Posts: 7
Threads: 2
Joined: May 2021
Reputation:
0
Hello,
I see in the manual (P68) : Nerd Menu in the table screen (SHIFT+NERD) to get to the presets and
"The following presets are available",
But, i bought my Nerdseq in second Hand, and : Preset Empty...How can i have this preset?
Thanks you!!!!
Olivier
Posts: 4.125
Threads: 138
Joined: Jul 2017
Reputation:
247
The presets are not on the SD card.
I assume you just use an old firmware.
Update to the latest and it’ll be fine.
PLEASE use the search function if something have been asked or discussed before.
Every (unnessesary) forum support means less time to develop! But of course, i am here to help! 
Posts: 7
Threads: 2
Joined: May 2021
Reputation:
0
Hi, Thank you for your answer, but i'm in the new firmware (1.24)
I try this morning to use the new firmware again, updating Succeed, and preset always empty :-(
I 'm formating my sd card...
and try again
Posts: 4.125
Threads: 138
Joined: Jul 2017
Reputation:
247
05-29-2021, 08:30 AM
(This post was last modified: 05-29-2021, 08:31 AM by XORadmin.)
The sd card is not needed for all of this.
If you run v1.24 then it is there.
Just shift+ nerd in the table. Go to the preset rule and select as always with shift left/right. Press OK to enable the preset.
I’m sure it’s fine!
PLEASE use the search function if something have been asked or discussed before.
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!
Posts: 7
Threads: 2
Joined: May 2021
Reputation:
0
so, i'm just so sorry, yes, it's work :-(
I'm a newbee with Nerdseq, but already in love!!!!
What a module!!!!
thanks thanks thanks
Posts: 4.125
Threads: 138
Joined: Jul 2017
Reputation:
247
Don’t worry :-)
Just remember that editing always happens like this.
PLEASE use the search function if something have been asked or discussed before.
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!
Posts: 128
Threads: 28
Joined: Jun 2022
Reputation:
1
I have the same problem except there's no presets. I select Shift+Nerd in the table (I imagine it doesn't matter what row you're in) and I get a screen which just has two possibilities (three if you count abort):
Preset > Empty
Release Table
Can you make any suggestions?
BTW, I'm in 1.25A.
Thanks in advance.
Posts: 128
Threads: 28
Joined: Jun 2022
Reputation:
1
Except there are no preset rules?
As you see I go into a table - I select Shift+Nerd in the table (I imagine it doesn't matter what row you're in) and I get a screen which just has two possibilities (three if you count abort):
Preset > Empty
Release Table
As you can see, these are the only possibilities, I don't have any rules to choose from.
