+- XOR Userforum (https://forum.xor.eu)
+-- Forum: Products (https://forum.xor.eu/forumdisplay.php?fid=3)
+--- Forum: NerdSEQ (https://forum.xor.eu/forumdisplay.php?fid=6)
+---- Forum: General Questions (https://forum.xor.eu/forumdisplay.php?fid=17)
+---- Thread: ramp spanning length of pattern (/showthread.php?tid=1434)
ramp spanning length of pattern - private_transfer - 08-29-2022
This is one of these things I feel like NerdSeq actually has 3 different ways to do this and I'm missing something...
What is the most direct way of making a ramp that starts with a beginning voltage and arrives at an ending voltage across the length of a pattern? I'm imagining this in terms of automating CV to open a filter.
I feel like one way to do this might be to generate an envelope with a long attack. I suppose I could also just fire off a trigger to something like Maths or pip slope to do the same thing. But I suspect NerdSeq actually has a more precise way to accomplish this. What am I missing here?
Thanks!
RE: ramp spanning length of pattern - mgd - 08-29-2022
1) You could use FX Glide. Not sure this will require readjustment when you change the tempo
2) Depending on you need regarding smoothness/steppyness you could simply set the output to some value and then use FX+ for linear or FX* for an exponential increase on each step. This way you would get 64 steps which should be beyond noticeable.
Thinking about it, 2) is what I would use.
HTH,
Michael
RE: ramp spanning length of pattern - XORadmin - 08-29-2022
Automator using tick as clock.
Set up as sawtooth, phase at 800.
Amplitude and offset as prefered.
RE: ramp spanning length of pattern - XORadmin - 08-29-2022
(08-29-2022, 04:47 PM)mgd Wrote: 1) You could use FX Glide. Not sure this will require readjustment when you change the tempo
2) Depending on you need regarding smoothness/steppyness you could simply set the output to some value and then use FX+ for linear or FX* for an exponential increase on each step. This way you would get 64 steps which should be beyond noticeable.
Thinking about it, 2) is what I would use.
HTH,
Michael
Or the same thing as table, would even be a higher resolution
RE: ramp spanning length of pattern - private_transfer - 09-06-2022
(08-29-2022, 08:01 PM)XORadmin Wrote: Automator using tick as clock.
Set up as sawtooth, phase at 800.
Amplitude and offset as prefered.
Thanks for this. Is there a way to stop the automation at the end of the pattern? I have ASL0 0000 right before the BRK but that doesn't seem to do anything. I don't see a parameter for stop.
RE: ramp spanning length of pattern - XORadmin - 09-06-2022
(09-06-2022, 03:34 AM)private_transfer Wrote:(08-29-2022, 08:01 PM)XORadmin Wrote: Automator using tick as clock.
Set up as sawtooth, phase at 800.
Amplitude and offset as prefered.
Thanks for this. Is there a way to stop the automation at the end of the pattern? I have ASL0 0000 right before the BRK but that doesn't seem to do anything. I don't see a parameter for stop.
I think ASL0 1xx was the start/stop function