+- XOR Userforum (https://forum.xor.eu)
+-- Forum: Products (https://forum.xor.eu/forumdisplay.php?fid=3)
+--- Forum: NerdSEQ (https://forum.xor.eu/forumdisplay.php?fid=6)
+---- Forum: NerdSEQ Expanders (https://forum.xor.eu/forumdisplay.php?fid=22)
+---- Thread: More CV 16 Glide Issue? (/showthread.php?tid=833)
More CV 16 Glide Issue? - broecker - 09-28-2020
Hello,
When using the Glide attribute on the More CV 16 NSA set to GLC:01 I noticed that my CV signal that was going from -5v (000) to +5v (FFA) now only glides between -5v and 0v. Should it not just smooth out the CV and not limit it to a 5v window? Please let me know.
Thank you,
RE: More CV 16 Glide Issue? - XORadmin - 09-28-2020
(09-28-2020, 03:54 AM)broecker Wrote: Hello,
When using the Glide attribute on the More CV 16 NSA set to GLC:01 I noticed that my CV signal that was going from -5v (000) to +5v (FFA) now only glides between -5v and 0v. Should it not just smooth out the CV and not limit it to a 5v window? Please let me know.
Thank you,
Hey,
i just tested it and it glides normally from -5 to +5 Volt here. There is no limit or window.
Is it possible that you already set it to the other value again before it reached the +5 Volt?
GLC01 is a really slow glide and it takes ca 3.5 seconds until it reached from -5 volt to +5 volt.
If you add like some glide-steps (eg GLS03) then it directly goes much faster with GLC01.
Maybe that is your issue?
Else, please provide me your projectfile so i can check if i can reproduce your issue.
RE: More CV 16 Glide Issue? - broecker - 09-29-2020
(09-28-2020, 08:55 AM)XORadmin Wrote:Thank you! I totally missed the GLS and how it related to the speed of the GLC attribute. Very much appreciated!(09-28-2020, 03:54 AM)broecker Wrote: Hello,
When using the Glide attribute on the More CV 16 NSA set to GLC:01 I noticed that my CV signal that was going from -5v (000) to +5v (FFA) now only glides between -5v and 0v. Should it not just smooth out the CV and not limit it to a 5v window? Please let me know.
Thank you,
Hey,
i just tested it and it glides normally from -5 to +5 Volt here. There is no limit or window.
Is it possible that you already set it to the other value again before it reached the +5 Volt?
GLC01 is a really slow glide and it takes ca 3.5 seconds until it reached from -5 volt to +5 volt.
If you add like some glide-steps (eg GLS03) then it directly goes much faster with GLC01.
Maybe that is your issue?
Else, please provide me your projectfile so i can check if i can reproduce your issue.