More CV 16 Glide Issue?

[broecker]

Hello,

When using the Glide attribute on the More CV 16 NSA set to GLC:01 I noticed that my CV signal that was going from -5v (000) to +5v (FFA) now only glides between -5v and 0v. Should it not just smooth out the CV and not limit it to a 5v window? Please let me know.

Thank you,

[XORadmin]

Hello,

When using the Glide attribute on the More CV 16 NSA set to GLC:01 I noticed that my CV signal that was going from -5v (000) to +5v (FFA) now only glides between -5v and 0v. Should it not just smooth out the CV and not limit it to a 5v window? Please let me know.

Thank you,

Hey,
i just tested it and it glides normally from -5 to +5 Volt here. There is no limit or window.

Is it possible that you already set it to the other value again before it reached the +5 Volt?
GLC01 is a really slow glide and it takes ca 3.5 seconds until it reached from -5 volt to +5 volt.

If you add like some glide-steps (eg GLS03) then it directly goes much faster with GLC01.
Maybe that is your issue?
Else, please provide me your projectfile so i can check if i can reproduce your issue.

[broecker]

Hello,

When using the Glide attribute on the More CV 16 NSA set to GLC:01 I noticed that my CV signal that was going from -5v (000) to +5v (FFA) now only glides between -5v and 0v. Should it not just smooth out the CV and not limit it to a 5v window? Please let me know.

Thank you,

Hey,
i just tested it and it glides normally from -5 to +5 Volt here. There is no limit or window.

Is it possible that you already set it to the other value again before it reached the +5 Volt?
GLC01 is a really slow glide and it takes ca 3.5 seconds until it reached from -5 volt to +5 volt.

If you add like some glide-steps (eg GLS03) then it directly goes much faster with GLC01.
Maybe that is your issue?
Else, please provide me your projectfile so i can check if i can reproduce your issue.

Thank you!  I totally missed the GLS and how it related to the speed of the GLC attribute. Very much appreciated!