+- XOR Userforum (https://forum.xor.eu)
+-- Forum: Products (https://forum.xor.eu/forumdisplay.php?fid=3)
+--- Forum: NerdSEQ (https://forum.xor.eu/forumdisplay.php?fid=6)
+---- Forum: NerdSEQ Expanders (https://forum.xor.eu/forumdisplay.php?fid=22)
+---- Thread: CV16 - calibration (/showthread.php?tid=888)
Pages:
1
2
CV16 - calibration - Kubase - 11-20-2020
Do I have to 'Get Calibration' on every power up? It seems that way so far.
RE: CV16 - calibration - XORadmin - 11-20-2020
(11-20-2020, 11:47 AM)Kubase Wrote: Do I have to 'Get Calibration' on every power up? It seems that way so far.
Why? It is factory calibrated and you only touch it if you need to calibrate it.
RE: CV16 - calibration - Kubase - 11-20-2020
I'm sequencing an osc - all good last night, power down and go to bed. Power up this morning and it's several octaves lower. Go to setup > get calibration and it's all fine.
RE: CV16 - calibration - XORadmin - 11-20-2020
I wouldn't know why 'Get Calibration' would make any difference. The NerdSEQ is not aware of any calibration setting within a expander. The Expanders handle these themselves.
And still, 'Get Calibration' doesn't change any setting and especially not something that is exactly some octaves lower.
So are you experiencing another issue? Which firmware is the expander running? Do you probably have other transpose settings within the NerdSEQ which send other notes?
RE: CV16 - calibration - Kubase - 11-20-2020
Nope, no transposing. Firmware 1.0. All I did before the osc was at the right pitch was 'Get Calibration'. I was playing the same sequencer row.
RE: CV16 - calibration - Kubase - 11-20-2020
It just happened again without powering off. When I go to the track setup all the calibration figures are zero.
RE: CV16 - calibration - XORadmin - 11-20-2020
(11-20-2020, 04:34 PM)Kubase Wrote: It just happened again without powering off. When I go to the track setup all the calibration figures are zero.
They are always zero when you enter the menu. Thats why there is a Get Calibrate function.
But usually you never got to touch it.
Do you have any other expanders in your system?
RE: CV16 - calibration - Kubase - 11-20-2020
(11-20-2020, 04:47 PM)XORadmin Wrote:(11-20-2020, 04:34 PM)Kubase Wrote: It just happened again without powering off. When I go to the track setup all the calibration figures are zero.
They are always zero when you enter the menu. Thats why there is a Get Calibrate function.
But usually you never got to touch it.
Do you have any other expanders in your system?
Yes, more triggers and the MIDI expander.
RE: CV16 - calibration - XORadmin - 11-20-2020
Not sure if this is the exact problem, but maybe this will help:
https://forum.xor.eu/showthread.php?tid=790&pid=4485#pid4485
If not, then let me know, then i got to check your sequence.
RE: CV16 - calibration - Kubase - 11-21-2020
Will give it a go thanks. There weren't any problems before I got the trigger expander so it could be that.