Triggers on the CV channel

[premini]

Hi, 
I am wondering if theres a way to make trigger signals on a channel's additional CV out.
Any clue?
Thanks,

Martin

[XORadmin]

You could set to 800 with offset to the right to set the trigger and on the next step to reset the trigger. For the rest there is no real trigger possibility for the CV outputs.

[castano]

Thanks!
So I add under MOD 800 and then 000 and keep doing that
for the next step and so on
that seems to work, but I have to start on step 2 to create the first trigger
Is there a way to have step 1 from the MOD create a trigger?

[XORadmin]

Thanks!
So I add under MOD 800 and then 000 and keep doing that
for the next step and so on
that seems to work, but I have to start on step 2 to create the first trigger
Is there a way to have step 1 from the MOD create a trigger?

MOD 800 sets the voltage to 5 volt  (if the offset switch is switched to the right) and MOD 000 sets it back to zero.
It should trigger on the first step and resets on the 2nd track. But keep in mind that it doesn't trigger of course if the MOD was already set at 800.

[castano]

Thanks!
So I add under MOD 800 and then 000 and keep doing that
for the next step and so on
that seems to work, but I have to start on step 2 to create the first trigger
Is there a way to have step 1 from the MOD create a trigger?

MOD 800 sets the voltage to 5 volt  (if the offset switch is switched to the right) and MOD 000 sets it back to zero.
It should trigger on the first step and resets on the 2nd track. But keep in mind that it doesn't trigger of course if the MOD was already set at 800.

---

Thanks for the info now I understand what is happening!