When using a USB keyboard with the More Video/IO expander, if I select “New Project” under the Project screen, I’m prompted to press Start to confirm. Pressing Start with the USB keyboard won’t work. I need to use the module’s built-in keypad.
Also, and I’m not sure if this is a bug report or a feature request, but the manual says that to execute the Mark and Copy/Paste operations with the USB keyboard, it should be done with “CTRL+C” and “CTRL+V” respectively. On my keyboard, this only works with the left CTRL key, not the right. It would be nice to be able to do it with either. If this behavior is intended (perhaps the right CTRL key is reserved for future use), then I recommend tidying up the language in the manual.
Thanks again for all the great work on the NerdSEQ. I upgraded to v2.01 just today and played around with it for another few hours afterwards. It’s the heart and soul of my modular rig and a joy to use.
Also, and I’m not sure if this is a bug report or a feature request, but the manual says that to execute the Mark and Copy/Paste operations with the USB keyboard, it should be done with “CTRL+C” and “CTRL+V” respectively. On my keyboard, this only works with the left CTRL key, not the right. It would be nice to be able to do it with either. If this behavior is intended (perhaps the right CTRL key is reserved for future use), then I recommend tidying up the language in the manual.
Thanks again for all the great work on the NerdSEQ. I upgraded to v2.01 just today and played around with it for another few hours afterwards. It’s the heart and soul of my modular rig and a joy to use.
