11-18-2023, 06:20 PM
Hi there,
From other posts and the manual, there is no separate 'Hz/Volt' calibration, right?
When measuring C-0, it's 0v in 'V/Oct' but 0.25v in 'Hz/V', C-1 is 1v and 0.5v resp., until C-5 is 5v and 8v (C-6 is out of the volt range for Hz/Volt).
The doubling in Volts is 'relative', there is no there is no 'offset to tune'. For instance, 0.5v and 1v and might be a C-1 and C-2 on old gear X, but a B-1 and B-2 on gear Y (on my Vintage MS20 case). Not a big problem, I can change it by detuning the MS20, but there is no such setting on the NerdSEQ, correct?
Cheers, Airell
From other posts and the manual, there is no separate 'Hz/Volt' calibration, right?
When measuring C-0, it's 0v in 'V/Oct' but 0.25v in 'Hz/V', C-1 is 1v and 0.5v resp., until C-5 is 5v and 8v (C-6 is out of the volt range for Hz/Volt).
The doubling in Volts is 'relative', there is no there is no 'offset to tune'. For instance, 0.5v and 1v and might be a C-1 and C-2 on old gear X, but a B-1 and B-2 on gear Y (on my Vintage MS20 case). Not a big problem, I can change it by detuning the MS20, but there is no such setting on the NerdSEQ, correct?
Cheers, Airell