11-22-2023, 10:12 PM
(11-20-2023, 12:57 PM)Tuttle Wrote:(11-20-2023, 12:02 PM)mgd Wrote: Not sure if that explains things, but when you restart an (analog) envelope it does "start" from where it is just then. AFAICT the NerdSEQ is replicating this behaviour.
Kind regards,
Michael
When you re-trigger the NerdSeq envelopes it doesn't matter where you are in the cycle it always appears to start from the beginning of the attack phase. But this isn't the issue. The problem is when you use 'ENV1..8 Start' as the source for a second envelope. It works fine as long as you don't re-trigger the source envelope before it's full cycle. If you do a trigger command is not sent to the second envelope. I'm assuming this is how the command works.
Not sure about the main module. On the CV16 there was a firmware update (V1.2 IIRC) that did fix this problem.