11-24-2023, 11:11 AM
(11-18-2023, 06:20 PM)Airell Wrote: Hi there,
From other posts and the manual, there is no separate 'Hz/Volt' calibration, right?
When measuring C-0, it's 0v in 'V/Oct' but 0.25v in 'Hz/V', C-1 is 1v and 0.5v resp., until C-5 is 5v and 8v (C-6 is out of the volt range for Hz/Volt).
The doubling in Volts is 'relative', there is no there is no 'offset to tune'. For instance, 0.5v and 1v and might be a C-1 and C-2 on old gear X, but a B-1 and B-2 on gear Y (on my Vintage MS20 case). Not a big problem, I can change it by detuning the MS20, but there is no such setting on the NerdSEQ, correct?
Cheers, Airell
Correct. There is no specific calibration here. You could add a fixed offset using the mappings of the upcoming firmware and output from another output. It would mean you use a 2nd output but I think at least it would do the job. I think I spent only attention to it when I added the Hz/V functionality and since then nearly no one ever asked for it.
PLEASE use the search function if something have been asked or discussed before.
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!