12-02-2023, 03:41 PM
(11-24-2023, 11:02 AM)XORadmin Wrote:(11-23-2023, 11:01 AM)Tuttle Wrote:(11-20-2023, 12:02 PM)mgd Wrote: Not sure about the main module. On the CV16 there was a firmware update (V1.2 IIRC) that did fix this problem.
This was a fix for a specific problem with re-triggered envelopes on the CV16. On the main module envelopes trigger perfectly every time. This issue relates to the 'ENV1..8 Start' command not triggering a second envelope in certain circumstances.
I understand. I got to get to the test bench and check this behaviour. Of course it should follow the retrigger. I assume I only check for a complete new start here which is not entirely correct then.
I did a little test and what is actually happening is that the follower envelopes look at the gates and in fact the gates stay on until the release phase kicks in. Of course I can change that behaviour but it is a bit too complex with possible side effects for now so I wil not make it for the upcoming release. Maybe you could use the same source for it which should create the same result in the most cases.
PLEASE use the search function if something have been asked or discussed before.
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!