12-06-2023, 06:07 AM
(12-06-2023, 05:00 AM)kriskeyman Wrote: Okay... setting up Multi-IO, please bear with me...
GOAL: F8R slider control of note probability on MIDI Track1... so I think F8R as 'leader' and NS as 'follower'
Nerdseq running 2.00 firmware
Multi-IO recognized as MIDI expander (on boot, X button is lit green and knob works for data entry)
Michigan Synth Works F8R connected to Multi-IO via I2C cable to I2C-B, cables are connected correctly; devices in same case.
In MIDI/I2C Setup...
I2C B Mode = 16N -> NS 1-16
I2C B In Address = Hex:31 Des:49
After save & reboot with this data, moving F8R fader does not register flashing red light on Multi-IO I2C B LED.
I'm stuck here ^
However, with the following configured in MIDI/I2C Setup...
I2C B Mode = NS -> 2x 16N 1-32
I2C B In Address = Hex:0 Des:0
... moving F8R fader does register flashing red light on Multi-IO I2C B LED.
Strangely, if I set I2C B Mode = NS -> 16N 1-16, there's no flashing red light again when moving F8R slider.
Thanks for the help!
The F8R is not set up correctly. You got to set it to be a leader.
PLEASE use the search function if something have been asked or discussed before.
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!