Multi-IO Expander

[XORadmin]

First of all, amazing update to the firmware, and an incredible new module with the Multi-IO. This has made me rearrange my modules and incorporate my 16n F8Rbank into the case and learn I2C connections. Well done XOR! This is a very fun and challenging addition to an already impressive sequencer/mini-computer.

I have a question regarding the 16n F8R via I2C on the Nerdseq and applying mapping. I have a fader assigned to control pitch on CV1, and it connects correctly (awesome) however it increases the pitch amount drastically. By the time the fader position reaches 1/4 of the full sweep, the note change goes from C-2 through A-8. Is there a way to spread this note change over the entire length of the fader throw?

Thanks a lot! 
I would first check in the f8r calibrations if it is calibrated well. Normally it should have a full range from zero to full with a little offset at the ends. 
In the mapping you can look up which values it generates and that should go from 0 to FFF. 
It is possible to manipulate the incoming data so it will be corrected and uses the full NerdSEQ range. But I would first check if and why the f8r is not using the full data range.