Hi,
So I finally got around to getting my modular set back up and decided I should dive in to the nerdseq. I have the trs a midi expander and wanted to see what was what with the Roland aria tb-3. I can’t seem to make heads or tails of how to make a slide happen. The Roland manual has the slide function set to cc 102. So far I’ve had no luck using this cc. I remember looking into this a long while back and finally got it to work by using two midi lanes and having a note overlap. I did that with the polyend tracker somehow but unfortunately can’t access that anymore because it died. So here I am trying to figure out slide on this. Any suggestions or ideas would be appreciated. Also would appreciate any nerdseq tutorials that focus just on mid would be great. It’s been almost two years since I’ve done anything with music and I feel like I’ve forgotten more than I retained over the years.
Thank you!
So I finally got around to getting my modular set back up and decided I should dive in to the nerdseq. I have the trs a midi expander and wanted to see what was what with the Roland aria tb-3. I can’t seem to make heads or tails of how to make a slide happen. The Roland manual has the slide function set to cc 102. So far I’ve had no luck using this cc. I remember looking into this a long while back and finally got it to work by using two midi lanes and having a note overlap. I did that with the polyend tracker somehow but unfortunately can’t access that anymore because it died. So here I am trying to figure out slide on this. Any suggestions or ideas would be appreciated. Also would appreciate any nerdseq tutorials that focus just on mid would be great. It’s been almost two years since I’ve done anything with music and I feel like I’ve forgotten more than I retained over the years.
Thank you!