Firmware 2.01A
On a new project, sending C0-C1-C2-C3 out of CV1 and then reading CV1 in the mapping screen produces values that are slightly incorrect. The result is when using the CALC P2NT pitch > note mapping about 50% of the octave notes are off by a semitone (usually lower, e.g. B1 instead of C2).
The linked video shows an example: apattern with programmed notes, the result of the CALC P2NT and the CV1 input on the mapping screen.
https://drive.proton.me/urls/ZMG037ZEEC#Oz7RX4L34iCD
On a new project, sending C0-C1-C2-C3 out of CV1 and then reading CV1 in the mapping screen produces values that are slightly incorrect. The result is when using the CALC P2NT pitch > note mapping about 50% of the octave notes are off by a semitone (usually lower, e.g. B1 instead of C2).
The linked video shows an example: apattern with programmed notes, the result of the CALC P2NT and the CV1 input on the mapping screen.
https://drive.proton.me/urls/ZMG037ZEEC#Oz7RX4L34iCD