04-30-2024, 09:13 AM
(04-29-2024, 05:43 PM)rubberband Wrote: I'm stuck on what is probably the last step in getting my drum matrix/MIDI setup working. I use the NerdSeq to trigger both a drum machine module (Flame Fire) and a sampler (1010 BitBox MK2).
My general problem is when trying to use the built in MIDI "trigger" options:
For the Flame Fire:
MIDI_GATx works, but with the known limitation that when multiple steps in a row have a trigger only the first will fire.
MIDI_TRGx doesn't trigger the module at all
For the BitBox:
MIDI_GATx works, but with the known limitation that when multiple steps in a row have a trigger only the first will fire.
MIDI_TRGx triggers the module, but not quite right (the progress bars for sample playback don't reset)
I've got around this for the Flame Fire using the mapping matrix: The module supports a MIDI note on/note off command for any note value on a single, discrete MIDI channel. So the first 8 columns of the drum matrix XMAP to the mapping matrix, where I have:
GLOB PULS ---- > MIDI TC 1 NOTE
GLOB PULS ---- > MIDI TC 2 NOTE
...
GLOB PULS ---- > MIDI TC 8 NOTE
This triggers all 8 voices perfectly.
Unfortunately the BitBox doesn't support this. However if I set the BitBox to read MIDI on Channel 10, and do this:
GLOB SQRW ---- > MIDI TC10 NOTE
Then I can see the BitBox cycle trough triggering all 16 sample pads correctly as the value from SQRW cycles.
So my question is: Is there a way in the mapping matrix to define what the NOTE value on a single TRS MIDI channel should be? Then I could do something like
CTRL XMAP 2RW > ---- ---- ----
SET A MIDI NOTE ON CHANNEL 10
GLOB PULS ---- > MIDI TC10 NOTE
16 times, once for each pad.
Is that even a thing? Could I use NTON and NTOF one after another? The manual says these MIDI commands use note numbers 0 to 127 but I can't figure out where to set the note value.
Sorry if this has been explained before - I've searched and asked on other forums and even had an email chat with the nice people at Flame. I've really tried to figure it out myself I promise!
A note without a gate or a gate without a note is not a thing with midi.
So setting a ‘pitch’ and adding a gate on/off is not possible.
You could just try to have 2 rows, one does a note on and one does a note off. The note value is derived from the source ‘result’. So a thing like ‘set var a #48’ (don’t know the exact syntax now, note number is 48) and one time with midi on and in the other row wit midi off could work.
I will add another option for the matrix to do also a midi on/off which should fix that problem. No guarantee if the sample is then triggered only short. Like that the sample stops immediately the note off comes in. I assume that should then be handled in the sampler itself.
Still don’t understand why some people reported it to work.
PLEASE use the search function if something have been asked or discussed before.
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!


