07-11-2024, 12:04 PM
Hello,
I have a strange problem that I'm trying to diagnose. I use mapping with triggers to the four inputs to advance four tracks at differing rates (basically a different clock for each track). Recently I am having an issue where when I first turn on the Nerdseq and start the tracks this mapping works as expected, but then if I stop those tracks for a while, and then try and start them again, the tracks are not being advanced (even though the incoming triggers are still present, confirmed by using those triggers outside of Nerdseq, but also by seeing the values change on the mapping screen). I am at a loss as to how to approach this because I can't figure out what causes this issue. I've reformatted my SD card but the problem still exists. I'm on v2.01.
Note that things work properly using the internal clock, so it's also not an issue with the outputs.
I've attached my project file if this helps at all.
Thanks for any suggestions!
I have a strange problem that I'm trying to diagnose. I use mapping with triggers to the four inputs to advance four tracks at differing rates (basically a different clock for each track). Recently I am having an issue where when I first turn on the Nerdseq and start the tracks this mapping works as expected, but then if I stop those tracks for a while, and then try and start them again, the tracks are not being advanced (even though the incoming triggers are still present, confirmed by using those triggers outside of Nerdseq, but also by seeing the values change on the mapping screen). I am at a loss as to how to approach this because I can't figure out what causes this issue. I've reformatted my SD card but the problem still exists. I'm on v2.01.
Note that things work properly using the internal clock, so it's also not an issue with the outputs.
I've attached my project file if this helps at all.
Thanks for any suggestions!