Mapping strangely stops working

[XORadmin]

One guess is that the CV IN does sometimes generate a value even if it is at zero volt
then. Like 0 is very close to 1 and 1 would generate already the triggers.
I do have a new user definable threshold in the upcoming version which could solve that possible issue. But I don’t know if it related (to the bursts).
I will check those out again and see if I can find anything and why it should possibly stop.

Okay, thanks for the insights. And thanks for looking into this! From my inspection the "low" of the trigger is reading around 060-150 and the high is at FFF so I would expect there would be enough discrimination between the levels there. If you want I can try and take a video of the mapping screen when the triggers are coming in.

Then I would expect that the trigger doesn't have a proper 0 level or the CV input is not calibrated correctly.
The Pass command doesn't have a threshold and so it is 0 or anything else. 060-150 is way beyond that!
The question is why does it seem to work then and my only guess is here that on the raising edge of the trigger the level goes below 0 shortly. But that is just a guess. I will check out your project this weekend and get back to you.