Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Setup strategies
#4
Thanks for the input!

I set up CV16 on channels 5 and 6. With channel 5 out to CV16 1-8, and channel 6 out to CV16 9-16. Channel 5 controls Plaits, and channel 6 controls Rings.

I set channel 7 up as midi and send that to Bitbox.

Channel 1 and 2 have 4 CV each to control the two oscillators on PH. These come from CV and Mod outs for channels 1 and 2, and channels 3 and 4.

I’m not using the gates on channels 1-4. I couldn’t figure about a way to repurpose these. It seems like I need the gate to trigger the envelopes which are output at the CV and Mod jacks, even if the gate at the jacks aren’t used.

It would useful if you could output an envelope from a trigger jack.

I still have channel 8 left over.
Reply


Messages In This Thread
Setup strategies - by soggybag - 08-06-2024, 02:48 AM
RE: Setup strategies - by mgd - 08-06-2024, 08:08 AM
RE: Setup strategies - by XORadmin - 08-06-2024, 10:00 AM
RE: Setup strategies - by soggybag - 08-06-2024, 10:36 PM
RE: Setup strategies - by XORadmin - 08-07-2024, 07:54 AM
RE: Setup strategies - by soggybag - 08-09-2024, 08:09 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)