08-07-2024, 07:54 AM
(08-06-2024, 10:36 PM)soggybag Wrote: Thanks for the input!
I set up CV16 on channels 5 and 6. With channel 5 out to CV16 1-8, and channel 6 out to CV16 9-16. Channel 5 controls Plaits, and channel 6 controls Rings.
I set channel 7 up as midi and send that to Bitbox.
Channel 1 and 2 have 4 CV each to control the two oscillators on PH. These come from CV and Mod outs for channels 1 and 2, and channels 3 and 4.
I’m not using the gates on channels 1-4. I couldn’t figure about a way to repurpose these. It seems like I need the gate to trigger the envelopes which are output at the CV and Mod jacks, even if the gate at the jacks aren’t used.
It would useful if you could output an envelope from a trigger jack.
I still have channel 8 left over.
Do you use 8 cv outputs for the plaits and also 8 CV outputs to control the rings? All CV16 outputs are used?
Envelopes can also be triggered in other ways. FX, Mapping, External…
Trigger outputs are 0/5 Volt by hardware design. And still if you are not using them from the local track, they can be used from all tracks, automators, mappings etc. One of the basic functions ;-)
I always get confused and think what does Midi have to do with is as you use ,channel‘ for different things. It’s tracks and columns mainly. Only Midi and the NSA use channels (while for the NSA it is a hardware channel).
PLEASE use the search function if something have been asked or discussed before.
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!

