Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Handling FX changes between patterns?
#1
I’m running into problems when I use FX changes in one pattern as they carry over to the next pattern. Specifically, I’m using the built in Automator envelopes, I change the attack peak or other parameters of an envelope in one pattern, then it’s stuck at that setting when the next pattern plays.

Q 1: is there an easy way to reset the envelope on a pattern change?
Q 2: would it be better to create two more envelopes and assign them with FX to replace the default envelope in one pattern? Is this possible?
Reply


Messages In This Thread
Handling FX changes between patterns? - by soggybag - 08-26-2024, 10:06 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)