NerdSEQ vs Precision Voltages

[VMG]

For question 2 the short answer is:
Only somewhat limited microtonality with the NerdSEQ. The resolution of the DACs used is 12bits which does allow for some microtonality. For further reference I suggest to read older threads, e.g. https://forum.xor.eu/showthread.php?tid=...ge#pid5895

Thank you for the response, Michael. While I used the term "microtonal", I am not talking about tuning per se... I'd like to set an output voltage (that I can see the value) that is not quantized to a scale. I can get decent results using Step Xx = C1, C#1, etc, though the Note selectors are not precise enough for some of the modulation voltage requirements of my project. It isn't world-shattering, but the Nerdy CV/MOD output voltages might need an assist from attenuators/attenuverters to achieve the precision I am after. So at scale, impractical (in my setup, at least.)

Thank you again! Explaining the DAC was very helpful to my understanding of the situation.

PS: I may have missed how to utilize this FX > VOLT offset (those 4000 steps) in CV/MOD steps. My understanding was this was limited to AUDIO tracks only. If this is available on CV/MOD FX, that is likely the solution to question 2.