[NO BUG] Unexpected LFO offset for CV/MOD outs

[XORadmin]

Thanks for confirming Thomas—it's by design as I expected.

It might be interesting to consider a way to increase the offset available in the Automator screen. As it is, LFO offset can only reach +5v. Having a full +10v range is useful in many situations. Perhaps there could be an option toggle for an additional +5v offset (like there is for invert)?

It is very unlikely that I will add any changes to the LFO's and I can't see an empty spot in the LFO section to add another 'switch' either. Also adding more offset will only limit the range..it will not enhance it. If you push it up to 6 volt (with the added CV output of 0 volt) for example which would be one theoretical result with a higher offset then you would have only 4 volt left on the positive half while the negative half would have 1 volt as a minimum value. You would shift the range up to clipping.

If you choose for a CV output as the automator destination then it is always a combination of the current CV value and the bipolar LFO/Automator result(s).

Ah ok, makes sense. The reason I was doing this was using an external MIDI controller via the Mapping Screen to set Automator amplitude and offset. This method can't output a full 10v (for example if the LFO speed is 0), so I was having to use up almost all of the Mapping Screen to bring in all 8 Automators and add offset to them there (and also losing resolution of the automators in the process). But that's just how I'll have to do it!

I am not sure if I can follow.
You could just set the 8 outputs to 800 / C-5 and then you got your offset (like as a setup, just the same as you set up your automators once). It will be saved with the project.
Then you need 2 pairs of 8 mapping rows to control the automator speed and amp. This does result in a full 10 volt range of the automators.

You can of course route the automators through the mappings and do any kind of manipulation with that. I don't think it is necessary in this case. The resolution should not really change by the way as the mappings are executed faster than the automators, so every automator sample should be used.