Release Candidate Firmware V2.03 RC1

[XORadmin]

i Hi Thomas

Hi

When mapping a MIDI signal through the Automator (Autom-Slot2 > MIDICC-CH1-#1), if I change the source and send an external MIDI signal instead (MIDCC-TCH1-#70 > MIDICC-CH1-#1), it still remains active on the previous source “Automator”. This happened to me on the 4th project output.

I got to check that but it should normally be fine. The first Midi CC input signal should change the destination after you changed the source.
Maybe you can show a little video about it showing the mapping screen. Also keep in mind that too much data can overflow the Midi bandwidth.

If I use the Automator to send a signal to a modulation output via mapping (Autom-Slot2 > CV-Pitch-MOD4), when I stop the Automator, the MOD output sends a medium-level signal instead of resetting to zero.

That is correct. Automators do work bipolar and zero is the neutral position. The mapping values are only positive and so the automators are mapped unipolar and the zero position of the automator is the middle position of the mapping.
The question is why do you use the mapping to send an automator to a CV output. The direct modulation matrix of the automator itself is much better for it and it works indeed 'bipolar'.

Imported pattern does not work

Is the version you use this release candidate? Did you export the pattern with an earlier version? Can you maybe attach the pattern here so I can check?


Also, this release candidate is not supported anymore. A new version which is in the making will replace this. I suggest to only use the stable version for now.