02-01-2026, 07:36 PM
Hey folks (and Thomas),
I'm writing because I also always seem to have trouble with the CBPB 1XX function. I have read the relevant section of the manual and also the above posts, but still have issues with the things getting out of sync. I'm only using the CBPB 1XX on the first step of the pattern, but as soon as the pattern repeats things start to get out of sync. Calling CBPB 1XX multiple times, even if its always in the 1st row, causes issues.
My performance scenario is this: I have groups of patterns on multiple tracks that get played, looped, etc. At some point I stop the Nerdseq, perhaps have some transitional material, and then start a new group of patterns below the first to start the next piece. Sometimes I want certain tracks to have new clock divisions when restarting the sequencer.
Using CBPB OXX doesn't really work, because the new division doesn't start until the NEXT pattern. Using CBPB 1XX does work, but that pattern can never repeat, or else that track goes out of sync.
I guess I'm looking for the proper workflow so that I can start a new piece, with a new clock division right away, but without the sync issues cropping up if the pattern is used again or repeats.
Any advice?
I'm writing because I also always seem to have trouble with the CBPB 1XX function. I have read the relevant section of the manual and also the above posts, but still have issues with the things getting out of sync. I'm only using the CBPB 1XX on the first step of the pattern, but as soon as the pattern repeats things start to get out of sync. Calling CBPB 1XX multiple times, even if its always in the 1st row, causes issues.
My performance scenario is this: I have groups of patterns on multiple tracks that get played, looped, etc. At some point I stop the Nerdseq, perhaps have some transitional material, and then start a new group of patterns below the first to start the next piece. Sometimes I want certain tracks to have new clock divisions when restarting the sequencer.
Using CBPB OXX doesn't really work, because the new division doesn't start until the NEXT pattern. Using CBPB 1XX does work, but that pattern can never repeat, or else that track goes out of sync.
I guess I'm looking for the proper workflow so that I can start a new piece, with a new clock division right away, but without the sync issues cropping up if the pattern is used again or repeats.
Any advice?