Release Candidate Firmware V3.01 RC1

[ianski]

BUG - MIDI note output stopping when using scales...

Play back MIDI notes from a MIDI assigned track with any scale = working fine as expected.

Live input MIDI notes on that track working fine in GLOBAL-AVOID-CHROMATIC scales.
If any other scale is used, there will either be no notes sent, or the first few and odd notes across a number of octaves.

Usually going back to chromatic will bring all the notes back as normal, but sometimes its impossible and requires a reboot.

This happens on all channels, but only affects the channel you are using at the time. Other channels still work as normal (unless you uses scales on them!)

There are no lights on the Multi-IO to indicate MIDI note out either when this happens.

It seemed worse on Track 8, but affects all tracks similarly.

MIDI data other than notes is still output as normal (such as pressure).

This happens with both Track scales and Global scales.

Can you share the project file, midi settings, possible note offset info etc?

Here we are, sorry I forgot.

I'm using MIDI input from a Launchpad Pro (note mode) on various channels via the TRS port, routed to various MIDI channels on the MIDI tracks then sending them out to the DEVICE port.  

I've avoided using channels 1~4 just in case it interferes with the Launchpad integration, so all my routings are INPUT 9~Track 1, INPUT 10~Track 2, INPUT 11~Track 3 etc.)

I've tried Tracks 1,7 & 8, and various different MIDI channels, and its always same behaviour when using any different scale.

Its the same behaviour regardless if the MIDI notes are set to input or record to the MIDI tracks.

If I select the HOST port out instead of the DEVICE port, I still have no note information on the Multi-IO lights.

No note offset or any kind of effects used other than break to make a shorter loop.

Everything works perfectly - any combination of MIDI notes/channels/tracks until I try to use an alternative scale, then the problems happen. I can hammer as many MIDI notes as I want in chromatic mode and its always worked fine.

I am only using one of the columns on the MIDI track to input & record to (so just the base channel for that track).

The problems happen if the sequencer is playing or not. 

In this project I was trying to use a scale on Track 8 - there is some other data on Track 7 (just a C-1 note playing a kick drum) so you can ignore that. As mentioned though the issue happens on any track that is set to MIDI.

Hope that helps.