Release Candidate Firmware V3.01 RC4

[666pastel]

Just attempted to update to 3.1, my nerseq will not take the update. After update success screen unit reboots to a blank screen and stays there even after power cycling. Updated back to 3.0 and works fine. Any ideas on how to get 3.1 to work?

Which file did you use and are you sure the filecopy went 100% well? I didn’t hear any issues so far from other users.

I used the file within the candidate firmware v3.01 at top of this page. It gets to 49% and says updating succeed, it does this with all other firmwares as well except this one will not work

I am also having this issue. im on an early version nerdseq, number 14 and I will not get past the 49% screen and it just keeps going to black after saying success screen.