02-19-2019, 05:14 PM
Im not using the LFO though, im using ext cv in. (a trigger in from intellijel steppy 1u module). because the lfo will be a static constant trigger out, and Im looking for varied patterns, hence the work around to get there.
about the pressing stop twice, your right, i just tried it, and it does work however i think its not a good permanent solution.
Normally it makes more sense to have the modules set up to be controlled by the nerdseq, but sometimes its nice to make it a little bit more on the spot so I have this steppy module to help out with that.
Sorry if what Im saying doesnt make sense. Im not always good at explaining what Im trying to ask about , but then again if i was, I think wouldnt need to ask in the first place.. : /
about the pressing stop twice, your right, i just tried it, and it does work however i think its not a good permanent solution.
Normally it makes more sense to have the modules set up to be controlled by the nerdseq, but sometimes its nice to make it a little bit more on the spot so I have this steppy module to help out with that.
Sorry if what Im saying doesnt make sense. Im not always good at explaining what Im trying to ask about , but then again if i was, I think wouldnt need to ask in the first place.. : /