Firmware V1.18 C

[ural]

Hi there!

I  tried upgrade to 1.18C. However it looks like I have a problem. Every time I'm pushing shift+copy+cursor up and switching electricity on Nerdseq says "no usable sd-card found", "try to restart" and "drive handle invalid"...

I can load samples and songs from this sd-card without problems, but firmware won't load at all.

What is wrong?

I'm nearly sure you didn't put the firmware file correctly onto the SD-Card.
Check the troubleshoot for the firmware update and instruction again. It'll work for sure if all is correctly.

https://forum.xor.eu/showthread.php?tid=4

And you don't need to power cycle. In the setup screen you can do a soft reset after you turned debug on. Then you don't have to power off/on the whole rack.

Thank you. Did everything again step by step. The same results - the same error messages as before.

Then I tried with debug + soft reset method. Nothing. Even no error messages Nerdseq just restarts itself without going into firmware update mode.

Maybe it is like this because I'm upgrading from 1.18B?