04-03-2019, 07:35 AM
It's on my list to fix after the coming update. A new input calibration will be added then.
What you could do as workaround right now is to change the output of CV1 in the calibration. With tuning the offset and range and using the auto calibrate function (with the cables connected as described in the manual), you could get to your needed results. It's a bit trial and error, but i think you should be finished within 5 minutes. Don't forget to calibrate to the original CV1 values again after you did that (best write down the numbers of CV1 offset and range (0 Volt/10Volt).
For input 2.3.4 you need to do that with CV2.3.4 of course.
I will add a easy to use calibration for the inputs so one can calibrate simply to the source.
What you could do as workaround right now is to change the output of CV1 in the calibration. With tuning the offset and range and using the auto calibrate function (with the cables connected as described in the manual), you could get to your needed results. It's a bit trial and error, but i think you should be finished within 5 minutes. Don't forget to calibrate to the original CV1 values again after you did that (best write down the numbers of CV1 offset and range (0 Volt/10Volt).
For input 2.3.4 you need to do that with CV2.3.4 of course.
I will add a easy to use calibration for the inputs so one can calibrate simply to the source.
PLEASE use the search function if something have been asked or discussed before.
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!