04-12-2019, 08:26 PM
It depends on your settings.
If you use modular clock, then pamela should start with the NerdSEQ. With modular clock there is no start signal, so slaves start when the clock appear and reset to the first step on a reset signal.
If you set both to sync24, then the story is different. Pamela should start then as the reset port is used as the run signal which is set when the nerdseq starts and reset when it stops.
So i think it's only about settings here.
If you use modular clock, then pamela should start with the NerdSEQ. With modular clock there is no start signal, so slaves start when the clock appear and reset to the first step on a reset signal.
If you set both to sync24, then the story is different. Pamela should start then as the reset port is used as the run signal which is set when the nerdseq starts and reset when it stops.
So i think it's only about settings here.
PLEASE use the search function if something have been asked or discussed before.
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!