06-01-2019, 10:57 AM
(This post was last modified: 06-01-2019, 11:03 AM by swashplate.)
Ah, sorry. You are right about the trigger.
But i couldn find any settings about the mod out.
At the release notes its indicated as:
- fixed the problem that when a whole sequencer row was 'triggered' (with shift) while playing that the sample tracks did not 'trigger' as well
But it does not seem to change the value at MOD out.
I'll check the manual and settings again, maybe there is something i had missed.
Edit: Ok i saw the manual and it says:
You can pre-listen a note by using the OK button. (Works also in combination with SHIFT)It is also possible to prelisten your sequence by holding the OK button and scrolling up/down. If a note value is filled in on the same step in the MOD column, then this note will be updated as well. (Allows ‘duo-phonic’ pre-listen)
It allows me to pre-listen when the mod out set to note value but not when its set to arbitrary voltage (like 800 for ex). This allows a workaround, but i would prefer if it updates mod out regardless of the value type selected.
But i couldn find any settings about the mod out.
At the release notes its indicated as:
- fixed the problem that when a whole sequencer row was 'triggered' (with shift) while playing that the sample tracks did not 'trigger' as well
But it does not seem to change the value at MOD out.
I'll check the manual and settings again, maybe there is something i had missed.
Edit: Ok i saw the manual and it says:
You can pre-listen a note by using the OK button. (Works also in combination with SHIFT)It is also possible to prelisten your sequence by holding the OK button and scrolling up/down. If a note value is filled in on the same step in the MOD column, then this note will be updated as well. (Allows ‘duo-phonic’ pre-listen)
It allows me to pre-listen when the mod out set to note value but not when its set to arbitrary voltage (like 800 for ex). This allows a workaround, but i would prefer if it updates mod out regardless of the value type selected.