hi, some questions..
1. when i set some output value (cv, mod..) in a patch this value is immediately distributed to its destination no matter if this patch is actually active in a pattern or not. is this the way it has to be?
2. that may be a bug? i have patch 00 and 01 which set different values for the same destinations (00 sets cv1 to x and 01 sets cv1 to y). patch 00 is on track 1 and patch 01 on track 2 and both use trigger1 but on different steps. when i change the cv1 setting on one of the patches both tracks output on cv1 what was last set for cv1 no matter which patch.
and feature requests:
3. what about shift-ok to clone a patch?
4. page up and down is unused in the patch editor. why not use it to go to the next or previous patch?
1. when i set some output value (cv, mod..) in a patch this value is immediately distributed to its destination no matter if this patch is actually active in a pattern or not. is this the way it has to be?
2. that may be a bug? i have patch 00 and 01 which set different values for the same destinations (00 sets cv1 to x and 01 sets cv1 to y). patch 00 is on track 1 and patch 01 on track 2 and both use trigger1 but on different steps. when i change the cv1 setting on one of the patches both tracks output on cv1 what was last set for cv1 no matter which patch.
and feature requests:
3. what about shift-ok to clone a patch?
4. page up and down is unused in the patch editor. why not use it to go to the next or previous patch?