Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
groove granularity
#4
(12-11-2019, 08:29 AM)depaffect Wrote: OOh I love a challenge!

Okay so whilst not perfect, I found a bit of a workaround

In an unused pattern, just use the fx column to automate the BPM

Note that the BPM change happens at the end of each step, so you kinda do it upside down

eg

FX1 column_______FX2 column

BPM 007F
BPM 0096________BRK 0000

So with the BRK command in the FX column, you only need to edit the top 2 rows of the pattern. Obviously adjust BPMs to get the right level of shuffle.

Thanks, I didn't think of that one. Seems annoying filling up a whole FX column. I assume this effects the global BPM, is that right?

(12-11-2019, 01:16 PM)XORadmin Wrote: And you can always set a track to double speed and double the groove values. I think you should get a higher resolution with this.
Thanks, I did think of this but was hoping for something more flexible. I tried today, and to get close (still not quite subtle enough) to what I was after with a 120 BPM pattern, I had to go up to 480BPM with a centre groove setting of O, so +/- of P/N. This is kind of OK, but the maximum BPM is 500, so it's somewhat limiting - e.g. no 140 bpm stuff.

Might it be possible in some future version to have something like groove settings of W,X,Y & Z be user definable in project settings with a higher resolution? or is the resolution limit baked into the engine?

For now, I will experiment with using external clock, although I would really like to use Nerdseq as the master.
Reply


Messages In This Thread
groove granularity - by colb - 12-10-2019, 11:43 PM
RE: groove granularity - by depaffect - 12-11-2019, 08:29 AM
RE: groove granularity - by XORadmin - 12-11-2019, 01:16 PM
RE: groove granularity - by colb - 12-11-2019, 07:43 PM
RE: groove granularity - by depaffect - 12-12-2019, 02:39 AM
RE: groove granularity - by XORadmin - 12-12-2019, 06:15 AM
RE: groove granularity - by colb - 12-12-2019, 06:42 PM
RE: groove granularity - by depaffect - 12-14-2019, 02:34 AM
RE: groove granularity - by colb - 12-14-2019, 05:11 PM
RE: groove granularity - by XORadmin - 12-14-2019, 09:11 PM
RE: groove granularity - by colb - 12-16-2019, 03:01 AM
RE: groove granularity - by mathieu morel - 12-26-2019, 01:35 PM
RE: groove granularity - by XORadmin - 12-27-2019, 12:34 PM
RE: groove granularity - by mathieu morel - 01-08-2020, 04:02 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)