Release Candidate Firmware V1.21 RC4

[Barney Rubble]

If I mix samples plus waves on the same track the stop sound and stop all sound is ignored - is it possible to change that behaviour ? 

Now the cat is out of the bag with waves I don't want to loose them just because I pushed the nerdseq into impossible places 

I can't reproduce that. Every sound that you want to stop, stops on either Note Off or on the Stop All Sound commands. i just tested all combinations again.

My excuse is I'm suffering with a really bad cold -  perhaps I was confused about the function of stop (all) sound blush:

I think I know what happened  - If you use stop all sound from a modular track then the command is ignored. 

Am I misunderstanding something - I've assumed that stop all sound refers to wave sounds only and can be stopped from modular track patterns.