12-08-2020, 06:53 AM
The mode change is probably sending some information out which shouldn’t normally be there. DAW’s might recognize these if they know that the launchpad is connected.
The fact that some of your synth maybe don’t have issues with that is mostly based on that their octave range starts at C-1 or higher (and trust me, they is no such definition as C-1 in midi, I am refering to notes 12 and higher).
The nerdSEQ supports the lowest notes (midi note 0-11). I think we all agree that if working with notes that with a note on they should be a complement note off. That is always the responsibility of the midi sender. Also the receiver usually never knows what is connected in the midi chain. And since you use the nerdseq in midi mode and not in launchpad mode, it can be anything.
I will check today (i assume you are talking about the usual launchpad pro) what it is sending exactly and also the difference with V1.21A.
The fact that some of your synth maybe don’t have issues with that is mostly based on that their octave range starts at C-1 or higher (and trust me, they is no such definition as C-1 in midi, I am refering to notes 12 and higher).
The nerdSEQ supports the lowest notes (midi note 0-11). I think we all agree that if working with notes that with a note on they should be a complement note off. That is always the responsibility of the midi sender. Also the receiver usually never knows what is connected in the midi chain. And since you use the nerdseq in midi mode and not in launchpad mode, it can be anything.
I will check today (i assume you are talking about the usual launchpad pro) what it is sending exactly and also the difference with V1.21A.
PLEASE use the search function if something have been asked or discussed before.
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!