12-27-2020, 10:17 AM
Me again. So, the manual says:
ASL0..ASL7 → Automator settings for Automator slots 0 ..7. Here you can change
manipulate all automator settings for each slot. Depending on which type of
automator you assigned to a slot you can change the value. The 3 Value digits have
special functions as following:
X00, The first digit (X) is the function of the automator, so if you for example
assigned a LFO to this automator, the first digit is being used to decide which LFO
setting should be changed. ( eg: Start,Stop, Reset, Speed, Offset, Invert, Amplitude
etc..). The 2nd 2 digits 0XX is for the value (scaled to 255 values).
How do I know what to program to say, start Automator 0, that I have set to an LFO? ASL0?FF for example. The 'tooltip' just says 'Effect'.
ASL0..ASL7 → Automator settings for Automator slots 0 ..7. Here you can change
manipulate all automator settings for each slot. Depending on which type of
automator you assigned to a slot you can change the value. The 3 Value digits have
special functions as following:
X00, The first digit (X) is the function of the automator, so if you for example
assigned a LFO to this automator, the first digit is being used to decide which LFO
setting should be changed. ( eg: Start,Stop, Reset, Speed, Offset, Invert, Amplitude
etc..). The 2nd 2 digits 0XX is for the value (scaled to 255 values).
How do I know what to program to say, start Automator 0, that I have set to an LFO? ASL0?FF for example. The 'tooltip' just says 'Effect'.