01-15-2021, 08:44 AM
(01-14-2021, 05:54 PM)Kubase Wrote: Was going to say also - don't forget that the modulator outputs can be set to notes as well. Should be easy to set it up the same way as MIDI then - C0, C#0 etc.
Yeah thanks. Finally got it working. I found working with “notes” in modulation way easier to understand. It wasn’t one to one, but in a 16 slice wave, I had to use 4 semitones between each step. I suppose that’s the voltage differential for each slice in the bitbox. Once I sorted this, it’s great. A little less straightforward than the MIDI approach, but with the “issue” of MIDI Channels per track, I think the CV approach is better. I can use the same modulation out from NERDSEQ and input into Bitbox for each break (so just one cable), which is great, and then set the trigger out in the FX, to change breaks (though I couldn’t figure how to preview with FX trigger only). I probably need the Trigger expander, and this way I could map all Bitbox pads to the NERDSEQ Triggers, I think? Thanks. Fun stuff!