Q re best practise for gates on CV16

[XORadmin]

I have two columns (setup as LOC CV5 + LOC MOD5). The LOC MOD5 column has ^11 wherever I want a gate to start and -16 wherever I want an explicit GATE OFF.

In one pattern I've changed all ^11 to TD1 and all -16 to TD0 and the Env is set to AD-SR. That basically works in so far as the Env is triggered with each note and stopped with each TD0. Using TD2 instead of TD1 on short notes gives even better results. Ok, I see light at the end of the tunnel

Now a "Global Change" function that does some form of "search and replace" for a column in a pattern, for a column or all columns for all patterns on a track and for all patterns in a project would come handy


Just out of curiosity and because I intend to get another CV16 anyway:
Would or will it be possible to have a track setup like this:
Track 1: CV1-6 of NSA1
Track 2: CV7-12 of NSA1
Track 3: CV13-16 of NSA1 + CV1-2 of NSA2


Thank you for your help,
kind regards,
Michael

Exactly: ^11 in a LOC xx column is not possible (I don't know what it does then out of my head right now).

TD1 is not triggering the envelope but gating it (Since it is in AD-SR mode and not one-shot). So it will stay in 'Sustain'  until TD0 starts the release phase.
TD2 does a 10ms Trigger, so the Envelope is gated for 10ms and released then again. Both are for sure usefull depending on your needs.

Track 1: CV1-6 of NSA1
Track 2: CV7-12 of NSA1
Track 3: CV13-16 of NSA1 + CV1-2 of NSA2

Actually that is not possible for Track 3. You can dedicate a track only to 1 expander.

Global 'Search and Replace' .....man you are killing me :-)